Oil & Gas
What this tool does
Sight-glass drawdown for a target pump rate, or the rate implied by an observed drop. This page says what the tool is for, in plain language. The working formula stays on the signed-in tool.
When to use it
Open Chemical Pump Sight Glass Calibration when this is the job: Sight-glass drawdown for a target pump rate, or the rate implied by an observed drop. That is usually a capacity, displacement, or geometry check from the pipe record.
Step-by-step
- Open Chemical Pump Sight Glass Calibration from the tool list.
- Fill Unit system, Mode, Rate unit, Target rate from the instrument, the drawing, or the job record. Use the unit shown beside each field.
- Fill the remaining fields the same way. Skip a field only when the screen marks it optional.
- Run Calculate when that control is on the page, then read every result row and any warning.
- Check the result against the site procedure and the manufacturer data before you change a range, a wire, a setpoint, or a weight.
- A free account can open this tool after signing in.
Inputs
- Unit system
- Imperial or metric. Pick one and enter every other field in that system.
- Mode
- Choose the Mode that matches the instrument, the drawing, or the job. Choices include Target rate to drop, Observed drop to rate.
- Rate unit
- Choose the Rate unit that matches the instrument, the drawing, or the job. Choices include qt/day, gal/day, L/day, mL/min.
- Target rate
- Target rate is the value you read from the instrument, the drawing, or the job record. Enter it in qt/day.
- Gauge tube ID
- Gauge tube ID is the value you read from the instrument, the drawing, or the job record. Enter it in in.
- Test duration
- Test duration is the value you read from the instrument, the drawing, or the job record. Enter it in s.
Results
- Result
- The reported value for Chemical Pump Sight Glass Calibration. Use the unit printed on that row.
- Warnings
- A warning means an entry is incomplete or outside what this tool will stand behind. Recheck the inputs and the site procedure.
Common mistakes
- Using a nominal diameter where the job needs the measured inside diameter.
- Forgetting that the site procedure may require a different method than this field estimate.
- Do not treat a result from Chemical Pump Sight Glass Calibration as a substitute for the site procedure or the manufacturer data.
Standards references
These are the standards and public references named on this tool. Clause numbers appear only when the catalog already cites them.
- NIST gallon 3.785411784 L; US quart is one quarter gallon
- Field factor 0.6572 mL/min per quart per day
- Cubic inch = 16.387064 mL
Offline and access
This engine can run offline after the server has cached it for the signed-in account.
A free account can open this tool in the workspace.