DP wet-leg / dry-leg level

What this tool does

Hydrostatic level LRV and URV for wet-leg or dry-leg differential pressure. This page says what the tool is for, in plain language. The working formula stays on the signed-in tool.

When to use it

Open DP wet-leg / dry-leg level when this is the job: Hydrostatic level LRV and URV for wet-leg or dry-leg differential pressure. That is usually a level or flow calibration, a bore check, or a valve you are about to size.

Step-by-step

1. Open DP wet-leg / dry-leg level from the tool list.
2. Fill Level span height, Height unit, Process specific gravity, Wet-leg height from the instrument, the drawing, or the job record. Use the unit shown beside each field.
3. Fill the remaining fields the same way. Skip a field only when the screen marks it optional.
4. Run Calculate when that control is on the page, then read every result row and any warning.
5. Check the result against the site procedure and the manufacturer data before you change a range, a wire, a setpoint, or a weight.
6. This help page is public. Opening the tool still requires a Pro session.

Inputs

Level span height

Level span height is the value you read from the instrument, the drawing, or the job record.

Height unit

Choose the Height unit that matches the instrument, the drawing, or the job. Choices include inches, metres.

Process specific gravity

Process specific gravity is the value you read from the instrument, the drawing, or the job record.

Wet-leg height

Wet-leg height is the value you read from the instrument, the drawing, or the job record.

Wet-leg specific gravity

Wet-leg specific gravity is the value you read from the instrument, the drawing, or the job record.

HP tap offset

HP tap offset is the value you read from the instrument, the drawing, or the job record.

Static blanket pressure

Recorded for the job. It must not change LRV or URV.

Results

Result

The reported value for DP wet-leg / dry-leg level. Use the unit printed on that row.

Warnings

A warning means an entry is incomplete or outside what this tool will stand behind. Recheck the inputs and the site procedure.

Common mistakes

• Using the wrong specific gravity, or forgetting a wet leg, a seal fill, or a blanket pressure.
• Mixing a head unit with a pressure unit without reading the unit on the screen.
• Sizing from a flow or a differential that is not the one in the line.
• Do not treat a result from DP wet-leg / dry-leg level as a substitute for the site procedure or the manufacturer data.

Standards references

These are the standards and public references named on this tool. Clause numbers appear only when the catalog already cites them.

• Hydrostatics (P = ρgh, expressed as head × specific gravity)
• ISA level-measurement practice for wet-leg and dry-leg calibration

Offline and access

This engine can run offline after the server has cached it for the signed-in account.

A free session can read this help page. The tool card shows the name and the short summary. Opening the tool requires Pro.